CNF1 to connect one 470ohm-2K resistance, then connect 3.3V, it’s very important, otherwise the ECU will be burnout.So pls keep in mind.ġ) BOOT and CNF1 must be connected when reading data.Ģ) Only connect BOOT not CNF1 When reading the password, otherwise the password can’t be read out. When reading, then Boot needs to add one small resistor and ground it. Therefore, during the reading process, there is an extra CNF1,then Boot outputs low level and CNF1 outputs high level.

Grounding, then follow the Ktag user manual to wire the cable and read the data.ĥ.For TPROT8-10,the Bosch Company set the anti-debugging mode, then reading EEPROM needs no password and then reading Flash needs password. The Infineon ECU before TPROT8 is not encrypted, then you directly uses the BOOT point There are 3 types of Bosch Infineon ECU :ģ) The Infineon ECU after TPROT10 which is what we call GPT encrypted.Ĥ. We advise you use Open Port2.0 as the protocol conversion equipment and work with PC.ģ. The switch board is designed to work with J2534, this device uses the Ktag cables so the user can refer to the Ktag wiring diagram.Ģ. How to use KTMFlASH ECU programmer Switch board?ġ. KTMFlASH ECU Programmer Software Install Guide

Then you turns the power off for 2 seconds and operating the software.Ħ-About switching, pls watch our video and instructions firstly.ħ- Recommend use Intel processors Computer Computers with AMD processors can only do one time ! When you are not turn off the power for 2 seconds, it may prompt again. If the software prompts ” turn off the power for 2 seconds”, you must turn off the power for 2 seconds. The highlight is to read Infixxxx’s ecu and gearbox ecu.ĥ-When reading encrypted Infixxxx or ecu, Firstly read the password file. Including software and instructions, and our testing video for you reference.Ĥ- KTMflash mainly supports ecu. And better do NOT CONNECT INTERNET, or will lock the device.ģ- This is our cd content. Reinstall computer system –> Watch our video –> Install the software Ģ- No Installed “ECU flash” software on the computer.

Notice About KTMFlASH ECU Programmer Software Installationġ- Must use our KTMflahs ecu programmer software. Latest KTMFlASH ECU Programmer Software Free Download KTMflash ECU Programming & Transmission Power Upgrade Tool Support V-A-G DQ200 DQ250 Infineon Bosch & 271 MSV80 MSV90 VXDAS KTMflash ECU programmer & transmission power upgrade tool is the hot sell baby in 2019.Newest KTMflash read the chip data, read and write ECU data, read transmission data etc at a high speed.Here ,we share KTMflash ECU Programmer software free download and install guide. KTMflash ECU Programmer & Transmission Power Upgrade Tool Software Free Download and Install Guide

Ecu flashing software free download